November 19, 2009
Articles

Lincoln in New Robotic Automation Partnership
Lincoln Electric Automation and JITECH are forming a global product partnership to develop simulation technology that will allow fabricators to automate structural steel products. StruCIM is described as a “powerful 3D simulation software system” that will make it possible to “simulate and evaluate alternative methods for the automation of modern steel fabrication operations.”
[Read the article]

AWS Releases New Oxy-Fuel Cutting Standard
The American Welding Society's AWS C4.2, “Recommended Practices for Safe Oxy-fuel Gas Cutting Torch Operation” has been published. The new volume describes the oxy-fuel gas cutting process and latest procedures and safety requirements.
[Read the article]

Big Reward from Ni-flux Cored Wires
Switching from standard solid-wire MIG welding products to nickel-flux cored wires helps a fabricator to achieve greater process reliability, better performance, and improved customer satisfaction on every job.
[Read the article]

Commentary: Crisis of Confidence
The financial correction of 2008 was only a preliminary event to the slow-rolling crisis that followed. For those of us working our ways through it, this sense of crisis has been heightened by the “take charge” attitude of elected officials and government regulators with a cascade of spending, lending, borrowing, and planning.
[Read the article]

Case Study

Protecting Sensors in Weld Cells - White Paper
Learn how to dramatically increase weld cell productivity, reduce unplanned downtime and lower cost. Improving sensor survivability in weld cells is one of the easiest and fastest ways to reduce unplanned downtime and lower cost. Click Here To View

Sponsored by Balluff

Announcements

IndustrialProductDemos.com is your home for interactive manufacturing and industry product demos. You will find animated tutorials that walk you through product features, parts, applications, and accessories.
Watch Demos!

Weldingweb Forum

Visit WeldingWeb.com, the most active online community and discussion forum among welding and fabricating professionals and enthusiasts.


Penton Media Logo

Copyright © 2009 Penton Media, Inc. All rights reserved. To learn how to reach this newsletter's thousands of qualified readers, e-mail Jon Burger or call him at 216.931.9355.
To reach this newsletter's editor, email Robert Brooks or call 216.931.9450.

 



You received this email at #email#

To subscribe click here. To unsubscribe click here. © 2009 Penton Media Inc., 1300 E. 9th St., Cleveland, OH 44114. Read our privacy policy